minus-squaresychthys@lemmy.worldto3DPrinting@lemmy.world•what in the world is going on here?linkfedilinkEnglisharrow-up4·5 days agoNot necessarily. If the flow is slightly too high then you’ll get inconsistent results like this. I had this happen as well and it drove me nuts until I went through Orca’s flow rate calibrations like 4 or 5 times. linkfedilink
Not necessarily. If the flow is slightly too high then you’ll get inconsistent results like this. I had this happen as well and it drove me nuts until I went through Orca’s flow rate calibrations like 4 or 5 times.