Some good points in the comments but the short answer is: No, that is a crimp on wire nut. You cannot remove it without destroying it. If you remove this crimp on connector do not try to reuse it as it will never be as reliable again.

Lemmy largely is very anti AI art. You’re basically going to a vegan convention and asking “Is it ok if I have a little meat? As a treat?”

Is there a well defined “then”? Shortcuts are hard to stop arbitrarily using. If your goal is to become a better artist I would focus more on practicing your art instead of fitting AI into your art.

What about self hosted AI image generators or companies who pay royalties to artists for units sold?

I think you have created complicated rules for “piracy I enjoy/condone is good. Copying that I don’t like is bad.”

I don’t see there being a lot of room for to ever defend piracy and also hate AI influenced art

Ha. I was looking at the wrong picture in the linked thingiverse file. It does fill them in. That does look better.

It means it has measured your bed and the left side of your bed is higher than the right. Don’t get twisted about the graphic as it can exaggerate the shape. Look at the numbers. I don’t know off the top of my head if those are excessive

It looks like you’re either way too close to the bed or your nozzle needs to be replaced. Looks like massive over extrusion. Fat fat print lines. Your model has no printing in the diagonal yet your print has it in almost every square. Maybe you’re failing to retraction.

Your landlord buys his air filters at the Freeze & Breeze where they sell frozen meats and HVAC supplies and their freezers have failed

Refrigerant slow leak?

Punch a hole in your refrigerant line and if the escaping gas smells the same then you know that’s what it was.

Except you’re not gonna sell any because I’m going to sell 42 tickets to a $21 prize. You’ll just be left with your $20 prize, $20 dollars, and 40 free tickets.

Ok.

40*$1-$20 prize=?

That will leave you with $20

Yes you’re supposed to relax it while it’s being stored but this wouldn’t cause that.

This thing was dropped on its front.

Don’t know if you got it like this or if you got someone else in the house but that y axis tensioner sticks out pretty far in the front and it looks like it got knocked pretty good.

IS THERE A CAVE?

13th Warrior. Solid action. Antonio Banderas and Vikings. Dudes taking care of business.

What kind of bed do you have? If your bed isn’t flat this can happen as well. I scrapped a magnetic PEI sheet because it was never gonna be flat enough for a whole smooth first layer for me