potatobro@lemmy.blahaj.zone to 3DPrinting@lemmy.worldEnglish · 4 days agoStay safe folkslemmy.blahaj.zoneimagemessage-square59linkfedilinkarrow-up1678arrow-down18
arrow-up1670arrow-down1imageStay safe folkslemmy.blahaj.zonepotatobro@lemmy.blahaj.zone to 3DPrinting@lemmy.worldEnglish · 4 days agomessage-square59linkfedilink
minus-squareStatick@feddit.onlinelinkfedilinkEnglisharrow-up3·4 days agoAre there instructions on what to check? I have an X1C from May 2023. Would that be affected?
minus-squareTurboWafflz@lemmy.worldlinkfedilinkEnglisharrow-up10arrow-down1·4 days agoI think it only affects the A1. On the a1, board 2 is the safe one. The circular black thermistor on the left side is the component that overheats
minus-squareStatick@feddit.onlinelinkfedilinkEnglisharrow-up2·4 days agoThank you for the quick reply!
minus-squarewashbasin@sh.itjust.workslinkfedilinkEnglisharrow-up1·4 days agoI’m having a hard time finding documentation on where to actually locate this board. Is it underneath the heat bed?
minus-squareTurboWafflz@lemmy.worldlinkfedilinkEnglisharrow-up2·4 days agothis is what I followed to get to it https://wiki.bambulab.com/en/a1/maintenance/ac-board-replacement
minus-squarewashbasin@sh.itjust.workslinkfedilinkEnglisharrow-up1·3 days agoThank you! I was struggling.
Are there instructions on what to check? I have an X1C from May 2023. Would that be affected?
I think it only affects the A1. On the a1, board 2 is the safe one. The circular black thermistor on the left side is the component that overheats
Thank you for the quick reply!
I’m having a hard time finding documentation on where to actually locate this board. Is it underneath the heat bed?
this is what I followed to get to it https://wiki.bambulab.com/en/a1/maintenance/ac-board-replacement
Thank you! I was struggling.