Ignore the bad quality, my cooling fan broke down. It was printed on 0.08mm layer height.
You must log in or # to comment.
It’s only a layer line if it’s parallel to the bed, otherwise it’s just sparkling print artefacts.
The vertical lines are probably ringing.
Ringing.
check your belts to make sure they’re not too tight (and tight enough, but probably just too tight.)
if that’s not the issue then check and tune acceleration and jerk settings. if you haven’t done full calibration stuffs, I’d recommend the guide by teaching tech
Ringing 100%. Need to do some Input Shaping tuning
Ringing. Oscillations after turning corner. Can improve the tuning
