The only tell is a slight bump on the seam line of the back. It’s 0.1mm layer heights and 0.6mm thick.
Printed in TPU, I was looking for a solution like this for a future project and wanted to share it with someone.
The only tell is a slight bump on the seam line of the back. It’s 0.1mm layer heights and 0.6mm thick.
Printed in TPU, I was looking for a solution like this for a future project and wanted to share it with someone.
Did you do it in CAD or did you hand edit the gcode?
CAD, got the parts designed up, then made 2 prints.
Print 1 is one half while print 2 I only printed the first layer. Aligned the 2 prints, then resumed printing.
I used magnets to hold the finished part down as to not move.
Were you able to remove it from the bed and re-align it? That’s some clean alignment.
Look closely in the middle and you will see a nook. That said the clear TPU is helping hide it